Load'N'Go Powerbody:
Load'N'Go with built-in Generator, Compressor and Optional Welder
Click here to view the Flash version of this Page
A. Welder master on off switch (Also activates battery boosting if equipped with option)
B. CV/MIG voltage adjustment for spoolgun or MIG feeders (Optional)
C. Tank Air Pressure Gauge.
D. Hourmeter/Tachometer (Shows RPM while running and hours while in stopped position.)
E. Low Fuel Light (Will come on when tank is 1/4 remaining.
F. AC Voltmeter  (This meter should run around 240 volts with generator switch in on position.)
G. Remote Start with Key and Choke
H. 110V plugs with 20 amp capacity.
I. 20 Amp circuit breaker resets for 110v and 240v plugs
J. Generator on Switch. Must be on when Generator is used.
K. 20 Amp 240 Volt receptacle
L. Welder control receptacle. (Matching Welder receptacle must be plugged in for controls on welder
lead to work.)
M. Air outlet. This air outlet is nonregulated and will be full pressure shown on Gauge above.
N. Main Weld current plug. (Booster cable plug in if equipped with optional 12V battery boost)
O. Weld selector switch. Switches between Stick weld, CM/MIG weld, and 12V Battery Boost
Remote Control Panel in
Side Compartment
1000 pound pull-out parts
drawer
Kohler engine
Transfer your Service
body and Power Systems
all at once
Easy to use. Fast to transfer
Fleetwest Transferable Truck Bodies, 1320 S. Priest Drive #101, Tempe AZ. 85281, Toll Free: 866-497-7200